distribution panel plastic Introduction:
LWHG series distribution box is a kind of modularized apperance with small volume industrial electrical box. Based on the advantages of being easy to install, it has excellent strucure and higher performance,and it's widely applied in building electrical distribution system's installation, industrial
electrical circuit and house rebuild fitment etc.
The main switch in the distribution box can be separately made of Schneider, ABB and Muller products. The leakage switch in the household distribution box is made of electromagnetic products. Small distribution box with the door casing steel not less than 1.5 mm thick, the color will be arranged, there was enough in the discharge line space, independent ground zero line terminal, to be sent before production samples approved by party a, supervision engineer contractor, high-voltage electrical boxes are all made of cold rolled plate electrolysis before surface treatment, subject to party a, supervision to the rear can inspection.
The main switch of the distribution box distribution panel plastic to the separate close should be connected with a copper bar (no bare conductor) and meet the requirements of the standard acceptance, can not be connected with copper wire; The section of the outgoing wire of the main switch and the section of the incoming wire shall not be less than that of the main switch. Loop marks should be typed and secured with plastic strips.
Requirements of Distribution Panel Plastic installation:
1. distribution box should be installed in a dry, easy to operate place. When the distribution box is installed, its bottom port is generally 1.5m away from the ground.
2. The wood bricks and iron parts required for the installation of the distribution box should be embedded. All kinds of embedded iron should be brushed antirust paint, and do a good job of obvious reliable grounding. When the wires lead out of the panel, the cable holes in the panel should be smooth and without burrs. The metal panel should be equipped with insulation protective covers.
3. All kinds of switch and automatic switch installed on the disk surface of the distribution box should not be charged when the blade moving part is in the open state. The upper end of the vertically installed switch and fuse is connected with the power supply and the lower end is connected with the load. Horizontal installation should be left power supply, right load.
4. the power indicator on the Distribution Panel Plastic, the power should be connected to the outside of the main switch, and should be installed a separate fuse. The position of the disk face brake should correspond to the branch road, and the card frame should be installed below it, indicating the road and capacity.
Hot Tags: distribution panel plastic, suppliers, manufacturers, factory, customized, wholesale, price, for sale, free sample, cortem junction box, ip65 motor junction box, 60a underground junction box, Plastic Electrical Junction Box, Junction Box Plastic, ip68 shallow round electrical box
